CUSTOMER SUPPORT 800-972-0726 or 860-767-7033 FAX: 860-767-7265

Helpful steps of use!

 

How to Use Wilt-Pruf® Ready-To-Use (RTU) Sprayer:

  1. Spray Wilt-Pruf® as long as the spray does not freeze on the foliage while spraying. Allow two or three hours for drying time in daylight (not necessarily sunlight). Wilt-Pruf® is a film forming polymer and needs ultraviolet daylight rays in order for the spray to set up or polymerize.
  2. Always shake well before using, just as you would with paint.

how-to-use-wilt-pruf

 

How to Use Wilt-Pruf® Concentrate:

  1. Spray Wilt-Pruf® as long as the spray does not freeze on the foliage while spraying. Allow two or three hours for drying time in daylight (not necessarily sunlight). Wilt-Pruf® is a film forming polymer and needs ultraviolet daylight rays in order for the spray to set up or polymerize.
  2. Shake or stir the concentrate containers (depending on the size of the container) thoroughly before pouring Wilt-Pruf® into the water.
  3. Wilt-Pruf® concentrate MUST be added to water … not water to Wilt-Pruf®. Make sure you have a container to pour the water into first.
  4. Mix it well!  An electric drill with a mixer attachment can be used to thoroughly stir a container.
  5. Once mixed, Wilt-Pruf® may be sprayed with any pressure type trombone, pump or power sprayer except hose end. The more pressure, the better the spray pattern!

Cleaning

After use, immediately clean spraying equipment with hot water and liquid dish soap and rinse well. Should you mistakenly spray a surface, immediately clean with hot water and liquid dish soap, or use kerosine. Then rinse well.  If it doesn’t come off right away, it will wear off with time, as it does on the plants.

 

how-to-use-wilt-pruf